GrandSeed

400-0599-111
CN

Product

R & D, production and sales of automation and intelligent equipment for electronic production line

Contact Us

contact us

Service Hotline:400-0599-111

Telephone:0755-27315580

LED Bulb aging lineCategory:LED Intelligent production line

Introduction:Guangshengde LED bulb lamp aging line structure configuration and characteristic picture

Description

Features of Guangshengde LED bulb aging line:

1. This equipment is dedicated to the aging of 220V and 110V LED energy-saving lamps. Observe the aging of the 220V LED energy-saving lamps in the high-voltage, medium-voltage, normal pressure, low-voltage, high-temperature, roaming, and impact voltage areas. Can it pass the aging of the above voltage section (Patent No.: ZL201220526602.7)

2. The tooling board can age the LED energy-saving lamps and fully meet the product aging time requirements.

3. Detection of impact beat circuit: Adopt Tianzheng brand voltage regulator 15KW voltage regulator 1 0-300V adjustable, with 6 zones in the whole line, and the impact time of each zone can be set on the touch screen interface.

4. Detect the normal voltage circuit: use Tianzheng brand voltage regulator 15KW voltage regulator 1 0-300V adjustable, set as low voltage test area. (The area is about 7 meters)

5. Detect low-voltage circuit: use Tianzheng brand voltage regulator 15KW voltage regulator 1 0-300V adjustable, set as low-voltage test area. (The area is about 7 meters)

6. Detection of high voltage circuit: adopt Tianzheng brand voltage regulator 15KW voltage regulator 1 0-300V adjustable, set as high voltage test area. (The area is about 7 meters)

7. The chain board can be aging single-head energized or double-head energized lamps, which can be switched freely on the touch screen, and manual switching is required.

8. Lamp aging is adopted, and fast T8 lamp holder fixture is installed. (The lamp holder fixture can be adjusted to 300, 600, 900, 1200MM);


Guangshengde LED bulb lamp aging line complete machine frame structure:

1. Body and frame: The frame is welded with 40×40×1.5mm square steel pipe; the body is made of 130×23×2mm special aluminum alloy profile for aging line.

2. The nose and tail guards are made by bending a 1.5mm cold plate.

3. Conveyor chain: adopt C212A double-pitch single-lug high-strength double-hole chain produced by Hangzhou Chain Factory. The 30*30 standard angle steel is used as the support rail, and there are two layers in total.

4. Chain plate: It adopts 2.0mm cold plate to be bent and rolled into 148×1390×57mm, each chain plate is equipped with a single air switch, and 4 sets of adjustable T8 fluorescent lamp holders. Two-way conductive wheels are installed at the bottom. The chain plate is sprayed with black plastic.

5. Conductive rails: The whole line is equipped with three conductive rails, using 5mm epoxy board and frame edge. Equipped with 3mm×30 stainless steel aging special conductive track.

6. The peripheral sealing plate of the vertical aging line body of the LED fluorescent lamp is formed by cold plate folding, and an observation window is used in the middle

Related Products